You set the time of departure to the timer, so it preheats your car for 2 hours. For example, you set the timer to 14 o’clock, the timer starts heating your car at 12 o’clock.
To set the time of departure:
1.Press the arrow button once, the clock now changes to the set time of departure
2. You can now change the set time of departure by pressing the arrows
3. When the time of departure has been set, the screen returns to the normal state that shows a clock.
To change the clock to the correct time:
1. Press both arrows at the same time, the numbers start blinking.
2. Adjust the clock by pressing the arrows
3. When the wanted time has been set, the screen will stop blinking after a few seconds and the correct time is now set to the clock.
So first you have to set current time with pressing two buttons at the same time, numbers should start blinking and set the time with arrows. When that is done you set the time you wish to leave with arrow buttons. It then starts to pre heat your car two hours before that time you set.
Not sure what is your intention. This is for pre drive block/interior heater in the winter. Don’t charge electric vehicles with these, they dont handle the amps that well 😬 Thats why its usually forbidden in the housing rules 😯
6 comments
I dont think you need to pre heat your car in this weather kek.
Instructions look pretty clear to me.
Use Google Translator on your phone.
Use the buttons located on your side.
https://preview.redd.it/gwu1zi39273d1.png?width=720&format=pjpg&auto=webp&s=baddf059ef03014aa59f65e3043c08436bc2c96b
You set the time of departure to the timer, so it preheats your car for 2 hours. For example, you set the timer to 14 o’clock, the timer starts heating your car at 12 o’clock.
To set the time of departure:
1.Press the arrow button once, the clock now changes to the set time of departure
2. You can now change the set time of departure by pressing the arrows
3. When the time of departure has been set, the screen returns to the normal state that shows a clock.
To change the clock to the correct time:
1. Press both arrows at the same time, the numbers start blinking.
2. Adjust the clock by pressing the arrows
3. When the wanted time has been set, the screen will stop blinking after a few seconds and the correct time is now set to the clock.
So first you have to set current time with pressing two buttons at the same time, numbers should start blinking and set the time with arrows. When that is done you set the time you wish to leave with arrow buttons. It then starts to pre heat your car two hours before that time you set.
Not sure what is your intention. This is for pre drive block/interior heater in the winter. Don’t charge electric vehicles with these, they dont handle the amps that well 😬 Thats why its usually forbidden in the housing rules 😯