Just scrape it off with a blade (any will do, you can get a “Ceranfeldschaber” if you feel the need)
There are scrapers for this kind of stove. Make sure to hold them at a very low angle to not scratch the glass. You can also try mixing baking powder with a bit of water to create a paste, put it on and soften it up that way.
You can get a razor blade scraper. Also to get it looking like new I use barkeepers friend
Is there an “Action” store nearby? The pink stuff paste will get this right off
I usually rub in some ceramic cleaning milk and then scrape that off with a ceramic razor blade.
Scrap with dishwasher tablets
Bar Keepers Friend
Weiman makes a product for this that’s a very lightly abrasive paste and comes with a sponge. It works wonders if you can get it in Germany. Sorry if you can’t, this just popped up in my feed.
Dr. Beckmann has a product exactly for this.
Backofen-Spray would also help. (I tried this without reading the instruction and was disappointed. After reading it worked fine. Key point is application of a little heat.)
11 comments
Dr. Beckmann Putzstein ~~Ceran~~ Glaskeramik
Just scrape it off with a blade (any will do, you can get a “Ceranfeldschaber” if you feel the need)
There are scrapers for this kind of stove. Make sure to hold them at a very low angle to not scratch the glass. You can also try mixing baking powder with a bit of water to create a paste, put it on and soften it up that way.
You can get a razor blade scraper. Also to get it looking like new I use barkeepers friend
Is there an “Action” store nearby? The pink stuff paste will get this right off
I usually rub in some ceramic cleaning milk and then scrape that off with a ceramic razor blade.
Scrap with dishwasher tablets
Bar Keepers Friend
Weiman makes a product for this that’s a very lightly abrasive paste and comes with a sponge. It works wonders if you can get it in Germany. Sorry if you can’t, this just popped up in my feed.
Dr. Beckmann has a product exactly for this.
Backofen-Spray would also help. (I tried this without reading the instruction and was disappointed. After reading it worked fine. Key point is application of a little heat.)