Our reader’s MSI RTX 5090 Gaming Trio OC connector melts during DLSS 5 testing

First user reports RTX 5090 with melted connector after testing DLSS 5

Just few days ago I shared a story that DLSS5 is probably a good candidate for power stress testing, only to receive a report from one of our readers about a melted connector. This case occurred while he was testing DLSS 5 Neural Rendering in NBA 2K27 (so the only official game, mind you). The affected card is an MSI GeForce RTX 5090 Gaming Trio OC.

The reader, who uses the nickname erek, also documented the incident and shared the details with us. Before the failure, he reported that enabling DLSS 5 increased GPU power consumption from roughly 450W under his previous workload to more than 600W. MSI officially rates the Gaming Trio OC at 575W. 

GPU-Z recorded 613.5W board power

A GPU-Z screenshot shared after the incident shows a maximum Board Power Draw of 613.5W. Erek says the card remained above 610W for a period rather than reaching that value as a brief spike. 

First user reports RTX 5090 with melted connector after testing DLSS 5© erek/VideoCardz

Keep in mind that GPU-Z is reporting total board power, not power through the 16-pin cable alone. The PCIe slot can also supply power to the graphics card, so a 613.5W board reading does not mean that more than 600W was necessarily passing through the GPU power connector.

Shortly afterward, erek reported that the card had stopped working. He noticed an unusual smell and checked the power cable. According to him, the connector was extremely difficult to remove because the plastic had melted and started bonding the plug and socket together. Photos show severe heat damage on several terminals of the MSI-branded 16-pin connector. 

First user reports RTX 5090 with melted connector after testing DLSS 5© erek/VideoCardzFirst user reports RTX 5090 with melted connector after testing DLSS 5© erek/VideoCardzIs DLSS 5 at fault here?

Neural Rendering adds a heavy compute workload, and another HardForum user reported power increasing from 435W to 520W after injecting DLSS 5 into Hitman 3. However, melted RTX 5090 connectors have already been reported under other workloads. So I would say it might have contributed, but it may not have been the exact cause. It is a fact that erek has been testing DLSS5 quite extensively, as he shared and the problem appeared during that test. 

First user reports RTX 5090 with melted connector after testing DLSS 5© erekUser also shared the story on HardOCP

Let’s see whether this remains an isolated case or whether more reports follow. If DLSS 5 can keep RTX 5090 cards at unusually high sustained power levels, NVIDIA may need to look at how much additional board power the feature can add under certain workloads. Given the lack of an official response to previous melted connector reports, users may once again end up relying on modders to fix it. 

Sources: VideoCardz